Installation from PC 
--------------------

1. Set the cursor under the RunOPL-icon (not under the OPL editor!) and
   press TAB. When the file selection screen appears, press TAB again.
   In the first line of the dialog box specify the name of the installation
   directory (where the new software is stored), e.g. REM::C:\PTEMP\
   A file selection list appears.

2. Select the file !setup3.opa (first file). Press ENTER. 
   SetUp3 now takes control. The screen goes blank for a few seconds. Don't panic.
   A file selector box appears.

3. If the file selector box shows the product name, just press ENTER.
   If the file selector box shows a language, choose a language of your choice.
   If your language is not mentioned, select "international", which is English.

4. The file transfer starts. If the product was installed before,
   SetUp3 will start a dialog asking you if you want to
     (Continue)     = Overwrite existing version
     (Other drive)  = Install new version on different drive
     (Options only) = Install options you did not install the first time.

5. SetUp3 asks you on which drive you want to install the software
   and on which drive you usually keep your data.
   We recommend flash memory for the system and usually RAM for data.

6. SetUp3 will ask you about optional modules. You can decide to install
   them now, or you can leave it for later.

7.SetUp3 will give instructions on how to proceed after the successful
   transfer.